COS Events
The following are the events related to COS.
Event ID: 37 (Severity: Warning)
Message | Some COS configuration items will not be active. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 38 (Severity: Warning)
Message | Vlan <VLAN_ID> QoS not configured on all new ports. Some QoS resources exceeded. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 39 (Severity: Warning)
Message | Too many QoS features enabled- mask resources exceeded. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 40 (Severity: Warning)
Message | QoS initialization failed for TCP/UDP priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 41 (Severity: Warning)
Message | Too many QoS ranges requested. Some configurations did not succeed. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 42 (Severity: Warning)
Message | Too many QoS lookups requested. Some configurations did not succeed. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 381 (Severity: Warning)
Message | QoS initialization failed for protocol priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for protocol based prioritization. |
Event ID: 382 (Severity: Warning)
Message | QoS initialization failed for Vlan priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for Vlan based prioritization. |
Event ID: 383 (Severity: Warning)
Message | QoS initialization failed for device priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for device based prioritization. |
Event ID: 384 (Severity: Warning)
Message | QoS initialization failed for Type-of-Service mode. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for TOS based prioritization. |
Event ID: 385 (Severity: Warning)
Message | QoS initialization failed for DiffServ priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for Differentiated Services based prioritization. |
Event ID: 386 (Severity: Warning)
Message | QoS initialization failed for port priority. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that there was an error during CoS initialization for port based prioritization. |
Event ID: 4599 (Severity: Warning)
Message | qos <CONFIG_TYPE> <IP_PKT_TYPE> range <SRC_PORT> <MAX_SOURCE_PORT> "DSCP" <DSCP_POLICY>: Configuration entry was removed as sufficient resources were not available on the switch. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Event ID: 5264 (Severity: Warning)
Message | The configured outbound rate limit for port <SRC_PORT> cannot be applied when linked at <PORT_SPEED> Mbps. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that the configured outbound rate limit cannot be applied at the current speed. |
Event ID: 5265 (Severity: Warning)
Message | The configured outbound rate limit of <SPEED> kbps has been removed from the configuration because it is below the minimum supported rate of 10-1000 kbps. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | COS |
Severity | Warning |
Description | This log event informs the user that an unsupported egress rate-limit has been removed from the configuration. |