Loop protection

In cases where spanning tree cannot be used to prevent loops at the edge of the network, loop protection may provide a suitable alternative. Loop protection operates in two modes:

Untagged

The default mode. This mode can be used to find loops in untagged downlinks.

Tagged VLAN

Finds loops on tagged VLANs. This mode can be used to detect loops in tagged-only uplinks where STP cannot be enabled.

The cases where loop protection might be chosen ahead of spanning tree to detect and prevent loops are as follows:

On ports with client authentication

When spanning tree is enabled on a switch that use 802.1X, Web authentication, and MAC authentication, loops may go undetected. For example, spanning tree packets that are looped back to an edge port will not be processed because they have a different broadcast/multicast MAC address from the client-authenticated MAC address. To ensure that client-authenticated edge ports get blocked when loops occur, you should enable loop protection on those ports.

On ports connected to unmanaged devices

Spanning tree cannot detect the formation of loops where there is an unmanaged device on the network that does not process spanning tree packets and simply drops them. Loop protection has no such limitation, and can be used to prevent loops on unmanaged switches.

Loop protection enabled in preference to STP