Viewing gateway and IPv6 route information

Syntax:

show ipv6 route [ipv6–addr] [connected]

Displays the routes in the IPv6 routing switch table.

ipv6–addr : Optional. Limits the output to show the gateway to the specified IPv6 address.

connected : Optional. Limits the output to show only the gateways to IPv6 addresses connected to VLAN interfaces configured on the switch, including the loopback (::1/128) address.

Dest : The destination address for a detected route.

Gateway : The IPv6 address or VLAN interface used to reach the destination. (Includes the loopback address.)

Type : Indicates route type (static or connected).

Distance : The administrative distance of the route used to determine the best path to the destination.

Metric : Indicates the route cost for the selected destination.

The following example displays output for show ipv6 route command:
Switch(config)# show ipv6 route

                         IPv6 Route Entries

Dest : ::/0                                            Type : static
Gateway : fe80::213:c4ff:fedd:14b0%vlan10    Dist. : 40   Metric : 0

Dest : ::1/128                                          Type : connected
Gateway : lo0                                Dist. : 0    Metric : 1

Dest : 2001:db8:a03:e102::/64                           Type : connected
Gateway : VLAN10                             Dist. : 0    Metric : 1

Dest : fe80::%vlan10                                   Type : connected
Gateway : VLAN10                             Dist. : 0    Metric : 1

Dest : fe80::1%lo0                                    Type : connected
Gateway : lo0                                Dist. : 0    Metric : 1