Filtering routed IPv4 traffic

For a given VLAN interface on a switch configured for routing, you can assign an ACL as an RACL to filter inbound IPv4 traffic and another ACL as a RACL to filter outbound IPv4 traffic. You can also assign one ACL for both inbound and outbound RACLs, and for assignment to multiple VLANs. For limits and operating rules, see IPv4 ACL configuration and operating rules.


[no] vlan <vid> ip access-group <identifier> <in out>

where: <identifier> =either a ACL name or an ACL ID number.
Assigns an ACL to a VLAN as an RACL to filter routed IPv4 traffic entering or leaving the switch on that VLAN. You can use either the global configuration level or the VLAN context level to assign or remove an RACL. Note: The switch allows you to assign a nonexistent ACL name or number to a VLAN. In this case, if you subsequently configure an ACL with that name or number, it automatically becomes active on the assigned VLAN. Also, if you delete an assigned ACL from the switch without subsequently using the "no" form of this command to remove the assignment to a VLAN, the ACL assignment remains and automatically activates any new ACL you create with the same identifier (name or number).
Methods for enabling and disabling RACLs