Disabling time synchronization without changing the TimeP configuration (CLI)
Syntax:
no timesync
Disables time synchronization by changing the Time Sync Mode
configuration to Disabled
. This halts time synchronization without changing your TimeP configuration.
The recommended method for disabling time synchronization is to use
the timesync
command.
Example:
Suppose TimeP is running as the switch's
time synchronization protocol, with DHCP
as the
TimeP mode, and the factory-default polling interval. You would halt
time synchronization with this command:
switch(config)# no timesync
If you then viewed the TimeP configuration, you would see the following:
TimeP with time synchronization disabled
switch(config)# show timep Timep Configuration Time Sync Mode: Disabled TimeP Mode : DHCP Poll Interval (min): 720