Copying crash data content to a destination device (CLI)

This command uses TFTP, USB or Xmodem to copy the Crash Data content to a destination device.

Syntax:


copy crash-data tftp <ip-address> <filename>

copy crash-data xmodem

These commands copy the crash data content to a remote host, attached USB device, or to a serially connected PC or UNIX workstation.

slot-id

a - h—Retrieves the crash log or crash data from the processor on the module in the specified slot

mm

Retrieves crash log or crash data from the switch's chassis processor. When "mm" is specified, crash files from both management modules are copied.

oobm

For switches that have a separate OOBM port, specifies that the transfer is through the OOBM interface. (Default is transfer through the data interface.)

You can copy individual slot information or the management module (mm) switch information. If you do not specify either, the command defaults to the mm data.

To copy the switch's crash data to a file in a PC:

Copying switch crash data content to a PC

switch(config)# copy crash-data xmodem pc
Press 'Enter' and start XMODEM on your host... 

Transfer complete
  • At this point press [Enter] and start the Xmodem command sequence in your terminal emulator.